Omtech K40+ CO2 Laser: Engraving & Cutting every material i could find.

Lets do a material test on the Omtech K40+, with every material from paper to Glass and everything in between.
In this video i see what is good and what is bad to cut and engrave.
You may find this useful to see if this fits in with the materials you use in your craft or hobby.
Materials tested:-
Paper
Vellum
Thin card
Thick card
Felt
Cotton
Foam
Thin Acrylic
Thick Acrylic
White Acrylic
Black Acrylic
Green Acrylic with glitter
Thin MDF
Thick MDF
Thin PLY
Glass
Slate
Composite material.

I hope you enjoy the video.
Please like and subscribe, and hit the bell notification so you dont miss out on future videos 😁👍

If you want to have a look or even purchase one of these units please try the link below, i may even get a small kickback at no extra cost to you 😃:-

* Coupon Code: frankslittleworkshop (This gives 4% off all machines on the UK website, excluding accessories, not just the K40+, so it’s a great deal).
* Affiliate Links:
* OMTech UK: https://omtech.uk/?ref=frankslittleworkshop
* K40+: https://omtech.uk/products/40w-co2-desktop-laser-cutter-with-a-300x200mm-engraving-area-k40-plus?ref=frankslittleworkshop

#frankslittleworkshop #tools #k40 #omtechK40Plus #omtech @omtechlaser #CO2Laser #materialtesting #WillItCutOnMyLaser #lasercuttingacrylic #laser cutPaper #LaserCutFelt #LaserCut #Acrylic #LaserCutFoam #LaserCutMDF #LaserEngravedGlass #LaserEngravedSlate

source