Can this desktop CNC machine the 6th hardest wood on the planet?

It might be a small CNC machine, but it’s a mighty one!
Help support this channel! https://www.patreon.com/Needitmakeit

I’ve had even more time with the machine making parts and I’d definitely recommend if you can to get the 4th axis, once you go 4th you won’t want to go back.

NIMT5POFF (5% off)
Carvera Air: https://amzn.to/46PjpMa
Carvera Air 4 axis: https://amzn.to/4aj6FQp

A short list to help support this channel, thank you so much for your help!
Bambu H2C – https://tidd.ly/3K3sSY9 (If you print with color, this is the way)
Bambu P2S – https://tidd.ly/3ISZkfq (Best value)
Bambu H2S – https://tidd.ly/4olSRbL (Most options for money)
Bambu H2D – https://tidd.ly/4q9RsHk (A dual color beast)
Bambu Filament Shown in Videos – https://tidd.ly/4hn6TYI
Rode Wireless ME mic (Saved me about 4+ hours/vid) – https://amzn.to/3vcMKAr
Mag clip (Super handy, but a little pricy) – https://amzn.to/3NBFvZe
dd

It isn’t the fastest CNC machine, but it can hog off quite a bit more material than I was expecting and the results were really good. There is a little bit of improvement in the software area and I think I’d replace the MDF bed with a steel one with precision holes and bolting positions instead. I’m going to try my dyson vacuum attached to the back, and I’m also going to try my air compressor too and maybe even play around with some ways to get better dust collection like replacing the steel panel at the back with a 3D printed one with a funnel for chips. I could also make one to connect to the back of the bed and a deflector to direct chips away from the door. Lots of potential for sure, but what’s important is that it works and that it’s easy to use.

#Carvera
#cnc
#smallbusiness

source