Rev up those fryers!! – EPISODE 14 3D Printing a 300% Scale LEGO Malevolence #3dprinting #lego

Episode 14 of 3D printing the LEGO Malevolence at 300% scale from scratch and I would genuinely rather build the Venator engines five times over than spend one more minute on these technic ion cannons. This was the most frustrating episode of the entire series — the technic wouldn’t move, the gray brackets kept snapping so I remade them bigger, the main wheel hub broke leaving the cannon pushed in, and I had to snap every missile pin just to get them in place. Then I spent five minutes trying to attach the cannon completely backwards. But somehow both giant ion cannons are finally on the ship. Added 100 pieces this episode bringing the total to 583 out of 1,101. The technic horrors are finally over — I think. Every 100 new followers adds another piece to the build. Every brick custom 3D printed at home on a Bambu P1S, FlashForge Creator 5, and ELEGOO Centauri Carbon 2 — alongside the in progress 250% scale 3D printed LEGO Barad-dûr and the just completed 150% scale 3D printed LEGO UCS Venator Star Destroyer.

#Shorts #LEGO #3DPrinting #LegoStarWars #Malevolence #StarWars #DIY #BambuLab #Flashforge #ELEGOO #3DPrintedLEGO

Follow the full build:
TikTok (daily updates): tiktok.com/mikemakesshi
TikTok (tutorials & tips): tiktok.com/makeitmike

Get the full Malevolence print profile and support the build:
https://www.patreon.com/MikeMakesShi

Want the printers, filament, and tools I use? All linked here:
https://linktr.ee/MikeMakesShi

source